Sartorius Cubis MCA10202S Series, Operating Instructions Manual

Page: 55 / 89

Cubis
®
MCA Operating Instructions 55
System Settings
7.5.15 Parameters in the “Device Settings / Date and Time” Menu
Parameter Settings Explanation
NTP configuration NTP operating status Activates or deactivates the time synchronization with the NTP server .
Server IP Saves the entered server ID for the NTP server .
Set the date and time Date format Sets the date display format to DD/MM/YYYY, MM/DD/YYYY, DD .MM .YYYY,
YYYY-MM-DD (ISO)*, YYYY:MM:DD, DD-MMM-YYYY or MMM-DD-YYYY .
Set date Saves the entered date .
Time format Sets the time display format to HH .MM .SS, HH:MM:SS (ISO)* or HH:MM:SS
am/pm .
Set time Saves the entered time .
Time zone Saves the selected time zone .
* Factory setting
7.5.16 Parameters in the “Device Settings / Safe Weighing” Menu
Parameter Settings Explanation
isoCAL execution
mode Off Deactivates the isoCAL function . This setting change is
not
available for all
models .
Show status field, manual
start If the device must be calibrated: The [isoCAL] button is displayed as the
predominant button in the operating display . The isoCAL function must be
manually triggered using the [isoCAL] button .
On, automatic execution* Activates the isoCAL function . The device is automatically adjusted as soon
as a trigger starts the isoCAL function .
On, automatic execution
with linearization (only if
possible) Activates the isoCAL and linearization function . The device is automatically
adjusted and then linearized as soon as a trigger starts the isoCAL function .
Safety level Off If the isoCAL function must be carried out: The device displays a status
message .
Warning* If the isoCAL function must be carried out: The device displays a warning
message . Some device functions are limited until isoCAL has been
executed: The displayed weight value is marked as invalid; printed data are
marked with [!] .
Strict If the isoCAL function must be carried out: The device displays an error
message . Some device functions are limited until isoCAL has been
executed: The displayed weight value is marked as invalid; the starting of
functions and saving of data in tasks is disabled; data output is
deactivated .
* Factory setting