CycleGlide Add-On Kit
Assembly Instructions
FINALLY – A COMPANY THAT
LOVES BIKES AS MUCH AS YOU DO.
Chances are, your bikes are just like ours - your most
valued possessions. And if it has the Saris name on it,
nothing we build goes out the door unless it’s worth
putting those possessions on. Call it obsessive. Call it
eccentric. We just chalk it up to caring a hell of a lot
about creating the last rack you’ll ever need.
Item Description
4 Bike Model
QTY
A
55” Gliders
2
B
Hooks Assemblies
4
C
End Caps
4
D
Small Screws for End Caps
8*
E
Wheel Sets
4
F
E-Ring
+
4*
G
Headed Pin
4
6021 - 2 bike add-on
READ THIS ENTIRE MANUAL BEFORE INSTALLATION
This manual provides instructions on how to install and use the CycleGlide bicycle storage system.
The instructions are written for a person with a basic understanding of tools and procedures.
Read the entire manual before proceeding. If you do not understand any portion of these instructions,
do not attempt to install the CycleGlide; consult your dealer.
CycleGlide - 4 bike
Installing your new CycleGlide bike storage unit is simple and can be done in just and hour or two. However, it is critical that the CycleGlide
be installed correctly according to the following instructions.
SAFETY PRECAUTIONS
CAUTION:
Failure to properly install and use the CycleGlide could allow the CycleGlide or bicycles to detach from the ceiling and fall,
injuring the bicycles and anything they fall upon, including you.
Use TOOls sAfely:
The procedures in these instructions require climbing ladders and operating power tools. Make sure you are
familiar with these tools and their safety procedures before attempting to use them when installing your CycleGlide system. In build-
ing construction, electrical wires are often attached to the edge of studs. If you contact an electrical wire while installing your CycleGlide
system you could receive a severe electrical shock, or start a fire. When drilling, make sure you are in the center of a stud.
Cautions on installation:
Do not overtighten mounting screws. Once a screw is tight, it does no good to tighten it fur-
ther, and may cause damage to the ceiling tracks by bending or deforming them. Only straight ceiling tracks will allow the gliders to roll
smoothly.
Contact with wires can give you a severe electrical shock, which may cause injury or death. If you do not
know where wires are, have the work done by an experienced crafts-person.
WARNING!
Tools Required
A
Phillips or 1/4”
Hex driver
B
Installation video available at www.saris.com
C
E
F
D
G
Parts Included
Pliars
*Extra parts may be included
+
Never use after market e-rings
