1
3 4
2
26
The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Wall Mount Installation - Square Clock
1) Install the single gang box in the wall. Leave at
least 4 inches between the top of the gang box and
ceiling. Confirm that the bottom of the gang box is
level with the floor.
Ceiling
Minimum
3) Detach the housing from the back of the clock.
Do this by inserting a flat-blade screwdriver about
1/8 inch into each of the slot holes until the housing
detaches. You may hear a snapping noise as the
latches disengage.
4) Release the mounting piece from the back of
the housing by sliding it towards the center of the
housing, then pulling it back and away from
the housing.
Mounting
piece
Housing
1
2
2) Run a CAT5 or CAT6 patch cable from a PoE
switch or PoE injector to the gang box. Confirm that
the switch or injector, as well as the master clock,
are connected to your network router.
KNOW YOUR NETWORK
Make sure that your network firewall is set to
allow communication between the clocks and
NTP servers. This means that Ports 80, 123,
and 1777 must be open.