_
English
_
•
Place the cutting blade onto the
feed screw with the blade facing
in front as illustrated (Fig.4). If it
is not fitted properly, meat will
not be grinded.
•
Place the desired cutting plate
next to the cutting blade, fitting
protrusions in the slot (Fig.5).
•
Support or press the center of the
cutting plate with one finger then
screw the fixing ring tight with
the other hand (Fig.6). Do not
over tighten.
•
Place the hopper plate on the
head and fix it into position.
•
Locate the unit on a firm place.
•
The air passage at the bottom
and the side of the motor
housing should be kept free and
not blocked.
MINCING MEAT
•
Cut all foods into pieces
(sinewless, boneless and fatless
meat is recommended, approximate size: 20 mm x 20 mm x 60 mm) so that they fit easily
into the hopper opening.
•
Plug in the unit and switch
the
ON
/
O
button to "
ON
", then switch
ON/0/R
button to "
ON
"
position.
•
Feed the food into the hopper plate. Use only the food pusher to push down the food (Fig.7).
•
After use switch the unit off and unplug it from the power supply.
REVERSE FUNCTION
•
In case of jamming switch off the appliance by pressing the
ON
/
O
button to "
O
" position
and
ON/0/R
switch to "
R
" position.
•
The feed screw will start to rotate in the opposite direction, and the head will get empty.
•
If it doesn't work, switch off the unit and clean it.
