Sanyo VA-EXH, Instruction Manual

Page: 9 / 70

8
English
HARD DISK INSTALLATION AND CONNNECTION TO DVR 1
INTRODUCTION
OT
HER
OPE
RATIO
N
z If expanding the number of hard disks to three or more,
install the first one to
3 and the second one to 4 ,
reattach the installation block that was removed in step 2,
and then install the last two hard disks to
1
and
2
.
[Attaching the installation block]
Insert projection A into hole B by sliding the center of the front
part. Align the positioning points on both sides two at a time
and secure the nine points with screws.
* Insert projection A properly or else the hard disk installation
block cannot be attached correctly.
* Tightening torque: 0.6 N•m - 0.7 N•m (6 - 7 kgf•cm)
7
After installing the hard disk, follow the
procedure shown in step 1 in reverse
order to close the cover.
Use the following procedures to connect the DVR to the
external storage unit.
1
Use the four external storage unit
cables included with this product to
connect the external storage unit to the
DVR.
z Even if there are only one to three hard disks, connect all
four external storage unit cables.
z Make sure to connect correspondingly numbered terminals
on the external storage unit and DVR.
2
Use the supplied bracket to secure the
external storage unit cables.
z Use another supplied bracket to secure the cables at the
DVR end as well.
Positioning points
B
Positioning points
A
Connecting the DVR
1 2 3 4
External
storage unit
connection
terminals
External
storage
unit
DVR
Rib
External
storage unit
cable
Rib
Bracket
(supplied)
Screws
(supplied)
e00_l8hcb_xe_7.book Page 8 Thursday, March 10, 2005 3:23 PM