Sanyo VA-EXH, Instruction Manual

Page: 6 / 70

English
5
1
HARD DISK INSTALLATION AND CONNNECTION TO DVR
Use the following procedures to install the hard disk in the
external storage unit.
z
The external storage unit must be off before commencing
the following procedures.
z Use only S-ATA hard disks from Sanyo. Operation by other
hard disks is not guaranteed. Contact the dealer for details.
1
Remove the four screws (two on each
side) securing the cover, and remove
the cover.
2
Remove the hard disk bay.
Remove the four screws (two on each side), and remove the
hard disk bay on top of the installation block.
z The position of the hard disk differs according to the
number of units being installed. Numbers are marked near
the hard disk bay. Follow the chart below.
z The positions are shown below.
z To install the hard disk in positions
3
and
4
, remove the
installation block, and then the hard disk bay.
[Removing the installation block]
(1) Remove the nine screws.
(2) Slide the center of the front part toward the back panel
and remove the hard disk installation block.
For instructions on how to attach the installation block, see
[Attaching the installation block]. (
J
P.8)
3
Attach the hard disk bay removed in
step 2 to the hard disk.
Secure the screws in the order (1-4) marked on the hard disk
bay.
* Tightening torque: 0.5 N•m - 0.6 N•m (5 - 6 kgf•cm)
Do not use a torque screwdriver.
z Included with this unit are short screws for securing the
hard disk and long screws for securing the external storage
unit cable bracket.
Use the short screws for securing the hard disk.
Installing the hard disk
No. of units Position No. of units Position
1
1
3
1
,
2
,
3
2
1
,
2
4
1
,
2
,
3
,
4
Screws
Hard disk bay
Screws
Front panel side
1
3
2
4
Screws
Screws
Position
markings
(
1 - 4 )
Screws
Ensure the fittings exceed 10 mm in height.
If not, repair them.
Fitting
“1”
“3”
“2”
“4”
Bring the hard disk
connector to the side
with “CN.”
e00_l8hcb_xe_7.book Page 5 Thursday, March 10, 2005 3:23 PM