Sanyo RM-X106W, Instruction Manual

Page: 4 / 8

BATTERY BACK-UP SYSTEM
POWER SUPPLY
ADJUSTING THE CLOCK
This unit incorporates a battery back-up system which protects
the clock, sleep timer and wake-up alarm functions from the
mains failure with the battery installed. During the mains
interruption, the clock display will go out, but the clock movement
remains in operation. The time display will be resumed when the
mains return.
Reset the time if the display time is incorrect.
When the mains lead is connected to the AC outlet for the first time, or
when the mains in this case, set the clock and timer again.
Connect the mains lead to an AC 230-240 V, 50Hz wall outlet.
!
The Radio on/off switch is mounted on the secondary side.
The unit is not disconnected from mains, even switched off.
Insert a standard 9V (006P/6F22) battery (not included) to
the battery compartment matching the polarity marked on
the battery compartment.
Note: If the time display is blinking when the mains returns after
a failure, the back-up battery is exhausted and must be
replaced.
BACK-UP BATTERY INSTALLATION (Fig.2)
3
1. Slide the RADIO ON/OFF switch to OFF.
2. While holding the TIME SET button, then press HOUR or
MINUTE button repeatedly.
3. Release the TIME SET button.