Sanyo ECO G SPW-GU055XH, Technical Data & Service Manual, Page: 58 / 242

3-12
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
Fig. 3-7
Fig. 3-8
Fig. 3-9
Fig. 3-10
Panel
Intake grille
Side panel
Insert into groove on
side below “O” mark.
Vinyl tape
Standard screwdriver
(wrapped with vinyl tape)
Cover
Receiver unit
Clamp
Terminal board
Clamp
Clamp
2. Wireless Remote Controller
RCS-TRP80ANG.WL for Ceiling Mounted (T, LD
Type)
2-6. Installing the Receiver Unit
(1) To take off the side panel, open the intake grille and re-
move the screw. Then remove the side panel by moving it
toward the front (direction of arrow). (Fig. 3-7)
(2) Wrap the end of a standard (flat) screwdriver blade with
vinyl tape. Then insert the screwdriver blade into the
groove on the side of the cover below the “O” mark, and
pry open the cover. (Fig. 3-8) (Take care not to scratch the
panel.)
(3) Pass the lead wire through the panel, then install the
receiver unit in the panel hole.
(The projections on the receiver unit engage the panel
holes to attach the unit.)
(4) Fasten the receiver lead wire to the fastener that holds
the louver motor wiring. (Fig. 3-9)
(5) Reattach the side panel.
(6) Route the lead wire from the receiver unit along the lou-
ver motor wiring and other wiring and fasten them with a
fastener. (Fig. 3-10)
* Access the hole at the top of the electrical component
box to draw in the wiring.
Do not twist the control wiring with the power wiring be-
cause this may cause malfunction.
Install a noise filter or take other appropriate action if elec-
trical noise disturbs the unit's power supply circuit.
* For the wiring and test run procedures, refer to “Wiring
the Receiver Unit” and “Test Run.”
NOTE