3-27
Control of W-3WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
3. Timer Remote Controller
17.
Operation mode change control indication
Displays when an operation mode is entered by the re-
mote control unit, while another operation mode has been
already selected. This indicates that the operation mode
cannot be changed.
18.
Disabled Feature indication
Displayed if the selected feature was disabled during
installation.
20.
Heating standby mode indication
appears when the fan of the indoor unit is stopped or in
low fan speed.
21.
/
/
/
Fan mode select indication
The selected fan mode is displayed.
22.
SWING indication
Appears while the fl ap swings.
23.
Flap position indication
Indicates the fl ap position.
24.
Filter indication
Appears when fi lter needs cleaning. Clean the fi lter.
25.
Inspection indication
Appears when the protective device is activated or when
an abnormality occurs.
26.
Ventilation indication
Appears when a fan available in the market is installed
and is operating.
27.
Oil indication
Appears when the engine oil needs to be changed. (Ap-
pears when the gas heat pump air conditioner is used.)
28.
Sleeping
Appears during the sleeping function.
29.
CAUTION
Appears when the protective device is activated or when
an abnormality occurs.
30. Unit No. indication
Indicates the unit No. of the selected indoor unit.
31.
TEST indication
Appears while in test operation.
1.
SETTING indication
Appears when the timer program is being set.
2.
UNIT indication
Indicates the unit No. of the indoor unit which is selected
with the Unit Select button, or the unit in which an abnor-
mality occurs.
3.
TIMER No. indication
Appears when the time program is being set.
4. Timer
program
: The indoor unit starts operation at the programmed
time.
: The indoor unit stops operation at the programmed
time.
5.
Today’s day of the week
Indicates today’s day of the week.
6.
Program schedule indication
Appears under days that are scheduled for program op-
eration.
7. Present
time
Displays the present time on a 24-hour clock. Also also,
displays settings in the various setting modes.
8.
TIMER OFF indication
Displayed when the timer has been turned OFF.
9.
ERROR indication
Displayed when a mistake is made during timer setting.
10.
Outing indication (
Outing function)
Appears when the outing function is set.
11. Upper and lower limit indication of the outing func-
tion
: Indicates the upper limit of the temperature
: Indicates the lower limit of the temperature
12. Operation Mode indication
Displays the selected operation mode. (AUTO
/HEAT
/DRY /COOL /FAN
).
13. Temperature indication
Indicates the set temperature.
14. °F / °C temperature unit indication
15.
Remote control sensor indication
Appears when the remote control sensor is used.
16.
Centralized control indication
Appears when operated in centralized control. If the
remote control operation is not permitted to the remote
unit, when the Start/Stop button, Mode Select button or
Temperature setting button is pressed,
fl ashes and
rejects the change.
Display Section (Refer to the page 3-22)
TD831139̲Sec3̲p25-40.indd 27
TD831139̲Sec3̲p25-40.indd 27
2008/04/17 19:16:26
2008/04/17 19:16:26
