SANY SY95C, Operation And Maintenance Manual

Page: 42 / 166

3-14
MACHINE CONTROLS
SY95C Excavator OMM
Date and Time Setup Screen
0003818
Figure 3-20
The Date and Time Setup screen is accessed by
selecting the Time Calibration icon on the Function List
screen.
The Date and Time Setup screen allows changes to the
date, time, and time zone:
• Press the button below the up/down icon (1) to
increase the value of the selected position.
• Press the button below the left/right icon (2) to select
the position for adjustment.
• Press the button below the check mark icon (3) to
confirm the adjustment.
• Press the button below the return icon (4) to return
to the previous screen.
System Unlocked Screen
SANY factory and authorized service only.
Reserved Function
Not used at this time; reserved for future function.
Diesel Particulate Filter (DPF)
Screens
0003121
Figure 3-21
When exhaust particulate deposits (soot) build up, the
diesel particulate filter (DPF) will need stationary
regeneration to remove the soot. Performing the
stationary regeneration process will make sure the
machine does not operate in a derated mode where the
engine rpm and power are reduced due to the exhaust
becoming clogged with soot.
The system will prompt the operator to start regeneration
with the DPF Tips screen. Read and understand the
operation procedures and precautions before starting
stationary regeneration.
NOTE: Press the button below the return icon (2) to return
to the previous screen.
1
3
2
4