Transport the Machine
SY75C Excavator OMM
4-34
Operation and Maintenance Manual — 0220
SANY
TRANSPORT THE MACHINE
Follow all local, state, and federal regulations and laws regarding transporting the machine.
Lift the Machine
To lift the machine use lift/tie-down points (a) identified on
both sides of the machine. The center of gravity point (b) is
identified on both sides of the machine to assist in rigging
and lifting.
Load the Machine
1. Clean track undercarriage.
2. Verify that the vehicle wheels are properly chocked.
3. Verify that the ramp to the vehicle has adequate strength and width and has a slope of 15 degrees or less.
4. Position the machine so that the centerline of the machine matches the centerline of the trailer.
5. Set auto deceleration to OFF.
NOTE:
See “Main Operator Screen” on page 3-25.
6. Set travel speed mode to slow.
WARNING!
To avoid a machine tip-over condition, do the following when loading or unloading:
• Select a firm and level location a safe distance from any road or structure.
• Ensure that the trailer wheels are properly chocked to prevent any movement.
• Use an access ramp with enough length, strength and width to properly support the
machine. The ramp grade should not exceed 15°.
• Drive slowly at the junction of the ramp and the trailer.
• Use a signal person to observe and alert the operator of any potential hazards.
Failure to observe and follow these warnings could result in death or injury.
Fig. 4-66
b
a
Typical
Summary of Contents for SY75
Page 2: ......