4-6
MACHINE OPERATION
SY60C Excavator OMM
WARNING
Do not remove the radiator cap while the engine is
hot. Engine coolant is under pressure. Allow the
engine to cool before removing the radiator cap.
Failure to follow this warning could result in death
or serious injury.
3.
If the over flow tank is empty, slowly loosen and
remove the radiator cap (2).
4.
Check engine coolant level in the radiator. Add
engine coolant until the level reaches filler opening.
5.
Install the filler cap after filling.
6.
If the engine coolant level in the over flow tank is low,
remove the filler cap and add engine coolant through
the fill opening of the over flow tank until the engine
coolant is at the FULL mark.
7.
Install the filler cap after filling.
Check Engine Oil Level
NOTICE!
Dispose of used oil in accordance with all
applicable environmental regulations. Failure to
do so could result in damage to the environment.
1.
Prepare the machine for maintenance. See
“Maintenance Safety” on page 2-5.
2.
Open the engine hood. See “Opening the Engine
Hood” on page 5-14.
0002862
Figure 4-3
3.
Remove the dipstick (1) and wipe the engine oil off
with a clean cloth and install the dipstick.
0002972
Figure 4-4
4.
Remove the dipstick. Make sure the oil level is
between the upper mark (2) and the lower mark (3).
5.
Install the dipstick.
NOTICE!
Do not add oil past the upper mark on the
dipstick, as this may result in engine damage.
0002856
Figure 4-5
NOTE:
The engine has two engine oil filler caps, one on
the valve cover and one near the fuel pump. Either
cap may be used to add engine oil.
6.
If it is necessary to add engine oil, remove the filler
cap (4) and add the needed amount of engine oil.
7.
Install the filler cap after filling.
8.
If the oil level is above the upper mark on the
dipstick, drain the excess oil. See “Change the
Engine Oil and Filter” on page 5-19.
1
2
3
4
