5-34
MAINTENANCE
SY60C Excavator OMM
• Dispose of the hydraulic oil and filters in
accordance with all applicable environmental
regulations.
Failure to do so could result in damage to the
environment.
NOTES:
• Always use the same type and grade of hydraulic oil.
• Hydraulic oil deteriorates faster on machines
equipped with a hydraulic breaker than on machines
equipped with a bucket.
1.
Prepare the machine for service. See “Maintenance
Safety” on page 2-5.
2.
Relieve system pressure. See “Relieve Hydraulic
System Pressure” on page 5-29.
3.
Remove the top access panel. See “Add Hydraulic
Oil” on page 5-29.
0003009
Figure 5-48
4.
Remove the four fasteners (1) securing the center
lower access panel (2). Remove the access panel.
0003010
Figure 5-49
NOTE:
For hydraulic tank capacity see “Fluid Capacities”
5.
Place a suitable container under the drain plug (3).
Remove the drain plug and allow the oil to drain.
6.
Install the drain plug and the center lower access
panel.
7.
Fill the hydraulic tank to the specified level. See “Add
Hydraulic Oil” on page 5-29.
Check the Hydraulic Hoses, Lines, and
Connectors
Check all hoses and lines for leaks. Replace damaged or
leaking hoses or lines immediately. Any hydraulic pump
lines or connectors connected to the engine
compartment must be replaced if damaged.
Make sure all hydraulic lines and hoses do not come in
contact with each other or with high-temperature engine
components.
2
1
1
3
