Machine Operation
SY50U Excavator OMM
4-34
Operation and Maintenance Manual — 0120
SANY
•
Do not drive or swing the machine on broken stones,
rugged surfaces, steel bars, or scrap iron. This could
cause personal injury or track damage.
•
Do not perform operations where the rubber tracks
may skid. This can cause early track wear.
•
Slow the machine when traveling on uneven ground. A
lower speed reduces the possibility of machine
damage.
•
Do not operate the machine on a surface covered by
small stones that could cause track skidding or damage.
•
Avoid premature track wear or damage. Do not operate
the machine on new asphalt or other hot surfaces.
•
Do not allow fuels, oils, salt, or chemical solvents to
make contact with the tracks. These substances will
erode the track links and cause rusting and peeling.
Wash these substances off the tracks immediately with
clean water.
Traveling at High Speed
When traveling at high speed, position the idlers to the front of the cab (sprockets to the rear of the cab).
Fig. 4-46
0002882
Fig. 4-47
0002884
