SY26U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 1119
4-21
T
ABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Inspection after Engine Shutdown
1. After shutting down the engine, conduct a walk-around inspection. Check the work equipment, the exterior of
the machine, and the undercarriage.
2. Check the engine coolant, engine oil, and hydraulic oil levels. See “Fluid Level Checks” on page 4-6.
3. Fill the fuel tank with diesel fuel. See “Add Fuel” on page 4-8.
4. Clear the engine compartment of combustible debris.
5. Clean mud from the tracks and undercarriage. See “Operation on Soft Ground” on page 4-38.
DIRECTIONAL ARROWS
The directional arrow (1) on each of the track frames
indicates forward movement of the machine. Check these
arrows before using the travel control levers/pedals. The
track drive sprocket is at the rear of the track frame.
If the track frame is facing backward, the travel direction
will be opposite the maneuvering direction of the travel
control lever/pedal. The machine will move forward when
you pull the control levers backward and backward when
you push them forward. Left and right control directions are
also reversed when the track frame faces backward.
Fig. 4-19
0003794
1
