Machine Operation
SY26U Excavator OMM
4-20
Operation and Maintenance Manual — 1119
SANY
ENGINE SHUTDOWN
1. Park the machine on a firm, level surface.
2. Lower the bucket or optional equipment to the ground.
3. Push the throttle control lever (1) forward (low idle) and allow the engine to idle for 5 minutes to cool down.
4. Turn the key switch (2) to OFF and remove the key.
Pull the hydraulic lockout control lever (3) back to the
locked (closed) position.
NOTICE!
•
Stopping the engine before it cools can
accelerate engine component wear. Never
abruptly shut down the engine except in an
emergency.
•
Never stop the engine suddenly when it is
overheated. Run the engine at low idle to
allow it to cool down gradually before
shutting it down.
Failure to follow this notice could result in
damage to the machine or cause it to operate
improperly.
Fig. 4-17
0003147
2
1
Fig. 4-18
0003154
3
