SY265C LC/SY265C LR Excavator OMM
5-8
Operation and Maintenance Manual — 0420
SANY
•
Check for fluid leaks.
Check the following after operation with the engine off and cool:
•
Check service points for wear or damage.
•
Clean the cab.
•
Check for fluid leaks.
•
Check for loose or missing fasteners and components.
Inspection and Maintenance for Severe Operating Conditions
If the machine will be operating under adverse conditions:
•
Check and clean any electrical components to prevent corrosion.
•
Check and clean any areas where extreme heat is present, such as the exhaust system, manifold, and
turbocharger.
For heavy-load operation, add grease to the pins of the work equipment prior to each operation. Cycle the operation
of all working parts several times before filling with additional grease.
Mud, Rain, or Snow Conditions
Before operating the machine, inspect each connector for looseness.
After operating the machine, clean the machine and inspect for missing or loose fasteners. Add oil and lubricating
grease as needed.
Near Ocean (Salt Air) Environments
Before operating the machine, inspect for any signs of corrosion. Apply grease where rust is found.
After operating the machine, thoroughly wash away the salt residue, apply grease where rust is found, and perform
maintenance carefully on the electrical components to prevent corrosion.
Dusty Environments
Clean the following components:
•
Engine air filter–Clean the dust valve frequently. Immediately service the air filter and housing if an
air filter restriction indicator is displayed. See “Check and Replace the Engine Air Filter System” on
page 5-34.
•
Radiator–Clean the radiator core frequently to prevent blockage.
•
Fuel equipment–Drain water/sediment frequently. See “Drain the Primary Fuel Filter” on page 5-28.
•
Fresh-air and recirculation filters–Clean the filters frequently.
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
