SY215C LC/SY225C LC Excavator OMM
Optional Equipment
SANY
Operation and Maintenance Manual — 1219
7-9
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
NS
OP
T
IO
N
A
L
EQUI
PMENT
Disconnect Optional Equipment
NOTE:
The following procedure details replacement of hydraulically operated equipment with a bucket.
Use the appropriate steps for your situation if replacing one hydraulically operated equipment with
another.
1. Lower the work equipment to the ground.
2. Shut down the engine.
3. Turn the key switch to ON.
4. Place the hydraulic lockout control lever in the
unlocked (open) position (1).
5. Fully cycle each pedal, joystick, and control lever two
to three times to release pressure in the hydraulic lines.
6. Place the hydraulic lockout lever in the locked (closed)
position (2).
7. Remove the wing nut (3) from the hydraulic tank
breather valve.
UNLOCKED
LOCKED
Fig. 7-15
2
1
Fig. 7-16
3
