SANY SY16C, Operation And Maintenance Manual, Page: 123 / 208

SY16C Excavator OMM Machine Operation
SANY
Operation and Maintenance Manual — 0420
4-51
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Removing from Storage
Follow the procedures below before using a machine that has been stored for a prolonged period of time:
• Clean the grease from the cylinder piston rods.
• Add oil or apply lubricant to all parts or components.
Starting the Engine After Long-Term Storage
1. Turn the key switch (2) to ON.
2. Pull the throttle control lever (1) backward (high idle)
and pause for 3 seconds.
3. Push the throttle control lever forward (low idle) and
start the engine. For additional starting information,
see “Starting the Engine” on page 4-16.
Fig. 4-73 0003147
2
1