SINUS PENTA
PROGRAMMING GUIDE
38
/
486
6. START-UP
MENU
6.1. Overview
For easier startup of the Penta drive, you can activate the Start-Up Menu. The Start-Up Menu is a wizard allowing
programming the main parameters for the connected motor and the parameters for PID control.
The parameters in this menu are the same as described in the FIRST STARTUP section.
The Start-Up Menu is displayed when the Penta drive is first started. The Start-Up Menu can be reactivated at any time.
To do so, set
P265
in “Start Up” mode (see the DISPLAY/KEYPAD MENU) and power on the Penta drive again.
The following is the root page of the Start-Up menu:
[ I D P ] S I N U S P E N T A
S T A R T - U P M E N U
P r e s s E N T E R
t o s t a r t
Press
ENTER
to enter the wizard.
Before entering the control parameters, you are asked to choose a dialogue language:
P 2 6 3 L a n g u a g e
→
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @
then you are asked to choose the display mode of the Start Up Menu:
W h e n d o e s t h e
S t a r t - U p M e n u
a c t i v a t e ?
→
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @
Choose one of the following:
1 : E V E R Y S T A R T - U P
2 : O N L Y N O W
3 : N E X T S T A R T - U P
4 : N E V E R
If you select “EVERY START–UP”, the wizard appears whenever the Penta drive is powered on;
if you select “ONLY NOW”, you can scroll through the menu and the wizard is disabled as soon as you quit the menu;
if you select “NEXT START–UP”, the menu is displayed only when the Penta drive is next started up;
if you select “NEVER”, the Start-Up menu is disabled.
