Installation Instruction
Widespread Lavatory Set
KRISS COLLECTIONS
Please read the instructions completely before beginning the installation.
Kriss I Collection
Model Number: 2220CN
Kriss III Collection
Model Number: 2220AN
Kriss Luna Collection
Model Number: 2220JP
Kriss V Collection
Model Number: 2220JZ
Kriss Crystal I Collection
Model Number: 2220JC
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2”
Rubber washer
1
Rev 06/2016
SPOUT INSTALLATION
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
1/8
- Remove the tee connector, spout mounting hardware and tee
connector washer from the bottom of the spout assembly. Apply
a ring of silicon caulking around the center hole on the top of the sink.
Do not use plumbers' putty which can damage the finish of the faucet.
- From the top of the deck, insert the spout's threaded shank through
the center hole of the sink. Make sure the spout flange washer is
properly placed underneath of the flange and gently pressed against
the sink top.
