SanRex SANARG 160P, Operator'S Manual, Page: 46 / 82

46
4.6 PARAMETER SELECTION
The Table below provides information of the parameters that are available for modification
using the front panel display. The table also provides information on the ranges available for each
parameter as well as to which weld process the parameter is available.
TABLE 4-3 : Front Panel Parameter Selection Ranges.
*1 : The values listed in the “Default” column are the “Factory Default Settings”. Once these are changed,
the last setting(s) before the unit is turned off will remain in memory for the next turn on. These NEW
settings will become the new default setting. The user must manually adjust the setting to the values in
the above chart to return to the “Factory Default Settings”.
*2 : Current Range : 1 to 85 A at 115VAC input
*3 : Pulse frequency units are dependent on frequency setting range as shown below:
Setting range Units
0.5 to 20 Hz 0.1 Hz
20 to 100 Hz 1 Hz
100 to 500 Hz 5 Hz
TABLE 4-4 : Pulse Frequency Range and Increments Units
Process
PARAMETER RANGE Default *1 Units STK LFT HF
Peak (Weld) Current 1 to 160 A *2 80 A 1 A YES YES YES
Base Current 1 to 160 A *2 120 A 1 A NO YES YES
Pulse Peak Current 1 to 160 A *2 120 A 1 A NO YES YES
Hot Start Current 0 to 70 A 20 A 1 A YES NO YES
Initial Current 1 to 160 A *2 30 A 1 A NO YES YES
Crater Current 1 to 160 A *2 30 A 1 A NO YES YES
Pulse Duty 15 to 80 % 50% 1% NO YES YES
Pulse Frequency 0.5 to 500.0 Hz 100.0 Hz *3 NO YES YES
Pre-Flow time 0.0 to 1.0 sec 0.1 sec 0.1 sec NO YES YES
Post-Flow time 0.0 to 60 sec 10 sec 0.1 sec NO YES YES
Spot Time 0.5 to 5.0 sec 2 sec 0.1 sec NO NO YES
Up-Slope Time 0 to 15 sec 1 sec 0.1 sec NO YES YES
Down-Slope Time 0 to 25 sec 3 sec 0.1 sec NO YES YES