SanRex CALPOTE UG Series, Instruction Manual, Page: 8 / 97

8
1.3 Wiring
WARNING
Required
 Use wires whose dielectric strength corresponds to the
circuit voltage. There is the risk of electric shock if you use
wires without dielectric strength.
 Fully cover the input and output terminals and the
conducting parts of the wires with tubes, tape, or other
such insulating objects. There is the risk of electric shock if
you touch exposed parts. If the input and output terminals
cannot be fully covered, ensure that direct contact with
the exposed parts is not possible.
CAUTION
Required

Use wires with the appropriate diameters to wire the input
and output terminals. There is the risk of heating or fire if
the wire diameters are too small.

Use crimp terminals with the appropriate size to wire the
input and output terminals. There is the risk of heating or
fire if the crimp terminals are not the appropriate size.
1.4 Maintenance/Inspection
WARNING
Required
 Replace parts with ones having the same ratings and
model. There is the risk of fire if different parts are used.
Prohibited

Do not touch the transformer, heat dissipation fins, and
other such parts that reach high temperatures. There is
the risk of burns if this instruction is not followed, even
after the input power supply is turned OFF (at which time
these parts may still be hot).