Sanremo 6713, Instruction Booklet

Page: 38 / 96

YOU Programming
38
By pressing one of the profiles you will access the
profile editing screen where it is possible to:
• view the profile graph;
• enable / disable the pre-infusion. If enabled,
the function pressure and duration can be
changed. This is a short, timed water jet used
to moisten the coffee pod before the actual
dispensing takes place;
• change the infusion pressure;
• enable / disable the post-infusion. If enabled,
the pressure and amount of delivered water,
expressed in ml, can be changed;
• customise the profile name.
Attention: the profile name can be changed by
clicking on it only in the screen below.
Custom profile 01
0
2
4
6
8
10
12
0 5 10 15 20 25 30 35
S
Press the arrows (<) or (>) to move between screens,
once the values have been changed, press the tick
“V” to save the profile.
Press the down arrow to return to the “Profiles
mapping” menu, press it again to return to the Main
menu.
11.4 MAINTENANCES QUICK MENU
Pressing the GEAR icon will display maintenance
alerts, if any.
11.5 NOTIFICATIONS - ALARMS QUICK
MENU
Finally, pressing the EXCLAMATION MARK icon
displays the notifications/alarms generated by the
machine. For NOTIFICATIONS, the icon will become
GREEN while for ALARMS it will become RED.
The alarms displayed on the machine are as follows:
• AL7 --> Dosing device alarm;
• Open circuit pump pressure AL11 --> Pump
pressure transducer disconnected;
• Open circuit steam boiler pressure AL4 -->
Steam boiler pressure transducer disconnected;
• Open circuit probe AL2 --> Steam boiler
NTC probe disconnected;
• Open circuit coffee boiler probe AL2 -->
Coffee boiler NTC probe disconnected;
• Closed circuit probe AL2 --> Steam boiler
NTC probe or coffee boiler short circuit.
Notification refers to Firmware updates performed
and maintenance to be carried out; alarms refer to
active alarms on the machine.