Sankosha DF-100E-V3, Instruction Manual

Page: 22 / 62

22
Let the machine cool completely before changing the cover.
Otherwise it may burn whoever is operating the machine.
Turn the power off before doing this operation.
For optimal performance use a factory original cover made only by Sankosha.
Using another company’s cover may give a bad finish. Sankosha takes no responsibility if
you do not use factory original covers & padding.
Cover/Pad Change Instruction
1. Lower Body Cover setting
①
Put Lower Body Cover on body and attach both side
Velcro tapes which are in the bottom of cover.
・ Don’t put side vent clamp support inside of
the cover in cover setting.
②
There are the covers for front and rear clamp
support plate and side expander plates inside
of the Lower Body Cover. Loosen strings of
those covers and put the covers on each plate.
Then tie the strings.
③
Pull strings which are attached on bottom of
Lower Body Cover under the metal fitting
and tie them not to leak blower outside.
Velcro tape
Side Vent Clamp Support
String Metal fitting
Lower Body Cover
CAUTION
Lower Body Cover