Sanken Samco SVC06, Instruction Manual, Page: 53 / 136

- 51 -
C
h
ap
ter
5
-
51
-
5-3 Status Display Mode
5-3-4 Frequency input
The frequency setting of the inverter can be input by using the quick knob with one of the following two methods.
(1) Frequency setting A
Turn the quick knob, and press when the required frequency is obtained, thus the frequency is changed.
This is the method of frequency setting A.

This is an effective method for setting a desired frequency.

Cancellation can be made during frequency setting.

In status monitor display, the method of frequency setting A can be used either during in running or
stopping stopped state of the equipment.

This method can not be used during alarm display.
Operation example: changing from 5 Hz to 50 Hz
Operation Display Description
or
Display of status monitor
(frequency display)
(press)
Press the quick knob, and the current set frequency will be
displayed
…
Turn the quick knob, and the value displayed will increase
or decrease.
…
Quickly turn the knob, and the displayed digit number of
increase
or decrease will be changed.
The frequency desired will be displayed.
（
*1
）
or
(press)
or
Press the
key or quick knob, then the set value will be
stored as a new frequency value. And the interface will
return to status monitor display mode. If this is done during
running operation, then the output frequency will start to
change to the newly set value.
:Lit :Brightness periodically changes : Flashing
*1 If it is not necessary to set frequency, press key or key to return to the status monitor display mode.