Sangoma Netborder SS7, User Manual

Page: 78 / 317

v1.14
78
Followings are the fields, that need to be configured.
Field Name Possible
values Default
Values Description
Protocol MEGACO
MGCP MEGACO Type of protocol Media Gateway is going to use.
NOTE: Currently Media Gateway supports only
MEGACO
Message Type
Identifier IP-PORT
IP
DOMAIN IP-PORT Media gateway message identifier (MID) type
field will be used to build the message identifier
field which Media Gateway will use in all the
originating messages.
For example:
If MID type is IP-PORT then Message identifier
format will be
“[IP-Address]:Port”
If MID type is DOMAIN then message identifier
format will “<Domain>”. Refer to Domain
section below.
If MID type is IP then message identifier format
will
“[IP-Address]”
Note: IP-Address, Port and Domain values will be
as defined above.
Signaling IP any ipv4 addr NA Media Gateway, Megaco, source IP address.
Port 1 - 65000 NA Media Gateway source Port.
Domain (a string value) NA Media Gateway domain name.
Used as MID Type, when MID Type is set to
DOMAIN. Ignored if MID Type is not Domain.
Default to system domain name.
Megaco Version 1
2
3 1 Megaco protocol version which Media Gateway
will use while communicating with Media
Gateway Controller
T.38 Fax Enable/Disable Enable If enable MG will configure to detect and send
CNG/CED Fax notify events to MGC. This will
prompt MGC to modify the RTP stream to T.38.
If disable MG will not notify MGC about
CNG/CED, thus disabling T.38 faxing. Fax will go