1.
2.
3.
4.
5.
6.
Certification Sticker
- 5 possible positions
Stand mounting point
(DC 5 V) - Connect power supply and/or power connector cable
Power connector
- To connect EXP100 to Host phone using supplied Ethernet cable
1 x Uplink Port
- To connect multiple EXP100 modules
1 x Downlink Port
- To connect EXP100 to Host phone using sheet connector
4x screw holes
Installation
The following Instructions illustrate how to mount the EXP100 directly to the Sangoma Phone.
If you wish to position the EXP100 in Stand-alone mode (detached from phone), simply skip the below hardware mounting instructions
and follow the cabling connection details
1.
2.
3.
If your Sangoma Phone is already in use, follow the instructions below to prepare it for the EXP100 (otherwise skip this section):
Remove the handset from your Sangoma Phone and lay it on a flat surface
Lay the Sangoma Phone down on a flat surface with the back of the phone facing up towards you
Remove the power cable (if used) and Ethernet Cable from the phone
