SANGFOR IAM v2.1 User Manual
203
user must be bound.
MAC addresses are scanned by the local device which applies the NETBIOS protocol. If it
fails to scan the MAC address, please check whether the NETBIOS protocol of the local
device is available, whether there is firewall blocking that, whether the firewall of the local
device is enabled, and whether the local device is configured with multiple IP addresses.
7.4.5.6.
Access Control Policy
SANGFOR IAM gateway device can configure access control policy for an individual user. Under
the [Edit User] default configuration page, click [Access Control Policy], and the corresponding
options appear, as shown below:
The configuration of access control policy here is the same with that in the above section (Section
7.4.3 Edit Subgroup), with the only difference that here you can configure [Inherit Parent Group
Policy] because user is independent member, and cannot have its own subgroup.
As to the introduction about it, please refer to the relevant part in Section 7.4.3 Edit Subgroup.
One user or user group can associate with maximum 10 access control policies.
As to the case that there are multiple access control policies, the matching order is as
