9
Set time Zone Switch [7] located on bottom of clock to your correct
zone as illustrated.
After the ATS program completes the AM/FM frequency set up the
following display — : — will appear and the symbol will blink
indicating the radio is searching for the radio controlled signal.
Once the radio receives the radio controlled signal the correct time
and date will be set automatically. Once the correct time and date
have been set, the symbol will stop blinking but the symbol will
remain on the display indicating that the time and date have been
set utilizing the radio controlled signal. The analog clock will follow
the radio controlled signal.
Manual time setting
TIME
Press TIME button, display will flash and previous allocated time.
Press SET button, the Hour digits in the time display begin to blink
with a beep.
1. Adjust the hour with key + or - .
2. Press the SET button once again to confirm the hour, now the
minute digits in the time display begin to blink.
Adjust the minutes just as you adjusted the hour:
1. Set the minutes with key + or -.
2. Press the TIME button once again to confirm the time setting with
a beep.
The second starts to count. The symbol will appear indicating this
is not radio controlled time.
