SBOX-7210 - User Guide, Rev. 1.0
// 28
5.1.
Opening and Closing the Chassis
The SBOX-7210 is factory configured to meet customer requirements. Kontron does not
recommend opening the system as this may cause damage to internal components.
Before opening the SBOX-7210, the system must be switched off and disconnected from
the main power supply. Also, disconnect all peripheral devices from the SBOX-7210.
Before you begin, ensure that you have a clean, flat and ESD-safe surface to work on.
For opening and closing the SBOX-7210, please perform the following steps:
1.
Close all applications. Shut down the system properly and disconnect the connection to the main power source.
Disconnect all peripherals.
2.
The SBOX-7210 should lay on a flat, clean surface with the top side facing upwards.
3.
Loosen and remove the Phillips screws (two located on the rear side of the chassis), that secure the top access
cover to the chassis. Retain the screws for later use.
Figure 5: Descrewing the top access cover of the SBOX-7210
4.
Slightly slide the top access cover forward to disengage it from the chassis. Some pressure may be required.
Figure 6: Disengaging the top access cover
