SBOX-7210 - User Guide, Rev. 1.0
// 17
2/
Electromagnetic Compatibility
For detailed information refer to section 10.3 ‘‘CE Directives and Standards’’.
2.1.
Electromagnetic Compatibility (EU)
This product has been designed for low level of radiated emission for residential, commercial and light industrial
environments and high immunity level for industrial environmental. This product complies with the European Council
Directive on the approximation of the laws of the member states relating to electromagnetic compatibility (EMC
Directive 2014/30/EU) and Radio Equipment Directive (RED Directive 2014/53/EU).
This is a class A product. In domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2.2.
FCC Statement (USA)
The following statement applies to the products covered in this manual, unless otherwise specified herein. The
statement for other products will appear in the accompanying documentation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Kontron is not responsible for any radio television interference caused by unauthorized modifications of this
equipment or the substitution or attachment of connecting cables and equipment other than those specified by
Kontron. The correction of interference caused by such unauthorized modification, substitution or attachment will be
the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral or host
devices. Failure to do so may violate FCC and ICES rules.
2.3.
EMC Compliance (Canada)
The method of compliance is self-declaration to Canadian standard ICES-003:
(English): This Class A digital apparatus complies with the Canadian ICES-003.
(French): Cet appareil numérique de la class A est conforme à la norme NMB-003 du Canada.
