S&T Kontron QDS-6100, User Manual

Page: 32 / 40

QDS-6100/6200 - User Guide, Rev. 1.0
www.kontron.com // 32
7.4. Microphone Input Wafer (MIC)
The microphone input wafer provides microphone (Mic-In) signals through the 2-pin 2.0 mm pitch wafer MIC.
Figure 15: Microphone Input Wafer (MIC)
Table 21: Pin Assignment (MIC)
Pin Signal Description Note
1 MIC+ Microphone input signal (+)
2 MIC- Microphone input signal (-)
7.5. UART Wafers (UART0, UART1, UART2, RS232/UART3 & RS232/UART4)
The 4-pin 2.0 mm pitch UART wafer UART0, UART1, UART2, UART3 and UART4 provide a serial data link between a
transmitter and a receiver. UART2 is intended for debugging. UART3 and UART4 support RS232.
Figure 16: UART Wafers (UART0, UART1, UART2, RS232/UART3, RS232/UART4)
Table 22: Pin Assignment (UART0, UART1, UART2)
Pin Signal Description Note
1 3.3V +3.3 V power supply
2 TX Serial Data Transmitter
3 RX Serial Data Receiver
4 GND Ground
Table 23: Pin Assignment (UART3, UART4)
Pin Signal Description Note
1 5V +5 V power supply
2 RS232-TX Serial Data Transmitter
3 RS232-RX Serial Data Receiver
4 GND Ground