KBox E-420-R1K/V1K - User Guide, Rev. 1.1
// 30
Figure 8: Descrewing the access cover of the KBox E-420-R1K/V1K (model w/ Phoenix connector)
4.
Lift the access cover up.
5.
Now you have access to the internal DDR4 SO-DIMM, mPCIe, M.2 Key B, M.2 Key M and Micro SIM Card slots /
sockets respectively in order to remove or install hardware components.
6.
For closing replace carefully the access cover to the system and screw it on with the retained screws.
7.
Tighten the retained screws when the cover is firmly in place.
When used as intended, the KBox E-420-R1K/V1K is to operate only in closed condition.
Only when the access cover is properly fixed with the screws and the front side with
WLAN and / or WWAN antenna(s) are properly installed and secured with the screws, it
is ensured that the user does not have access to the internal parts of the KBox E-420-
R1K/V1K.
5.1.1.
Installing SO-DIMM Memory Module(s)
To install memory module(s) please proceed according to the steps described:
1.
Open the device as described in the subsection 5.1 "Opening and Closing the Chassis" (step 1 - 5).
2.
Locate the SO-DIMM memory sockets (DIMM1 & DIMM2) (Figure 5, pos. 1).
3.
Align the notch on the SO-DIMM memory module with the notch in the SO-DIMM memory socket.
4.
Insert the SO-DIMM memory module into the corresponding socket at a 30-degree angle.
5.
Rotate the SO-DIMM memory module down until it snaps into place and the levers close.
