3.5"-SBC-VR1000 - User Guide, Rev. 1.7
// 33
7/
Internal Connectors
7.1.
Power Connector
Power connector must be used to supply the board with +12 VDC (±5 %).
Hot plugging any of the power connector is not allowed.
Hot plugging might damage the board. In other words, turn off main supply etc. to make
sure all the power lines are turned off when connecting to the motherboard.
7.1.1.
Power Input Wafer (CN7)
The 1x4-pin 3.0 mm pitch power input wafer pr12 V DC to the board.
Figure 12: Power Input Wafer CN7
Table 18: Pin Assignment CN7
Pin
Signal
Description
Note
1
+12Vin
Power +12 V
2
GND
Ground
3
GND
Ground
4
+12Vin
Power +12 V
Connector Type
B2W, 1x4-pin, 3.0 mm pitch
Mating Connector
Vendor
PINREX
Housing Model No.
733-75-M104B6
Terminal Model No.
733-70-FT0006