2
1
3
4
With the ignition switched off and the parking brake set, disconnect
the negative battery cable on the passenger side then remove the
engine cover.
Note: Failure to disconnect the battery may cause the
CEL to illuminate upon completion of the installation and subsequent
operation. Do not skip this step
!
Tool Required:
10mm Socket/Wrench
Disconnect MAF sensor and vacuum lines from the stock
intake tube.
5
Loosen hose clamp on the intake tube at the throttle body.
Tool Required:
10mm Socket/Wrench
Un-latch clips on the airbox and remove intake tube
assembly and stock air filter from the vehicle.
Loosen the two bolts securing the airbox and remove
airbox from the vehicle.
Tool Required:
10mm Socket/Wrench
6
Remove MAF sensor from stock intake tube
Tool Required:
Phillips Screwdriver
5
INSTALLATION STEPS:
