Quick Start -DT4
Attach the VGA cable to your monitor (if you are using a monitor to access the system).
Connect the USB IN port to additional USB ports located in the system, or to a laptop for example. The USB B port provides
additional internal USB connections to the system if needed.
The DIP switches 1-8 are set to the default: ON, ON, OFF, OFF, OFF, ON, OFF, ON; Leave the defaults for now. You can
consult the SBExpress-DT4 User Guide later for additional options.
Four additional USB ports (2 USB ports as shown on the back of the system and 2 internal USB ports, not shown) for
optional devices and connecting peripherals are available if needed.
A serial COM port (19200 8n1) is available if needed for connection to a serial console.
1.
2.
3.
4.
5.
Ports / onnectors
Step 1: Unpack Contents
SBExpress-DT4 NVMe SSD Test System chassis
Power cord
Ethernet cable
USB cable
Open the shipping container and unpack all contents.
Make sure you have the following:
SBExpress-DT4 NVMe SSD Test System - Front
Step 2: Plug in the Power and
Network Cables
COPYRIGHT © 2021 SANBLAZE TECHNOLOGY, INC.
[email protected] | [email protected] | www.sanblaze.com
All information in this document is subject to change. Configurations rely on host system BIOS support and may be restricted by the host. Contact SANBlaze for additional information.
Gen4
p/n 400-000023
Step 3: OPTIONAL STEPS
Plug the Power Cable into the system.
Plug the Ethernet cable 1G Eth0 into your network.
The SBExpress-DT4 should already be populated with the risers that
you ordered. See the list of PCIe Gen4 slots available (to the right).
1.
2.
3.
Step 4: Install Drives in Front
All drives are installed through the front panel. Up to three single or dual port drives can be installed in the SBExpress-
DT4 NVMe SSD Test System. Note: It is recommended that all drives be installed before the system is powered on so
that they are discovered properly.
Six PCIe Gen4 slots Available
Slot 0, 1, 2 Gen4 Riser; options for U.2 /
U.3 / M.2 / EDSFF (short)
Slot 3, PCIe x8
Slot 4, EDSFF (long) support built-in
Slot 5, M.2 (on Motherboard)
SBExpress-DT4 NVMe SSD Test System - Rear
