© SAMSUNG Telecommunications America
1
OfficeServ Wireless Quick Set Up Guide
Step 1:
Connect System Components
1.
Turn off system power.
2.
Insert WLI into slot (500R2:1 to 3; 100R2: 1 to 3 of base cabinet; 7200: 1 to 5).
3.
Load IDCS 500R2 or 100R2 or 7200 system with MCP2 software version 2.4x or up.
4.
Use MMC 806 to install card.
5.
Connect Combo APs (aka. WBS, WBS24, AP, type A, CWBS) to WLI using straight data cable;
pin assignments for 500R2 and 100R2
6.
Turn on power.
a.
Combo AP power LED will be on after all data are programmed.
Step 2: Pre-determinate the following data
1.
System ID or SSID
2.
System Key
3.
System IP address
4.
System Gateway IP address
5.
AP RF channels (frequency planning)
6.
AP IP addresses
7.
Handset IP addresses
e.g.
Sample Configuration Table (1 WLI + 2 Combo APs + 4 Handsets)
1.
System IP:
165.213.97.185
2.
System gateway:
165.213.97.1
3.
System ID:
123456 (must be numeric, max 6 digits)
4.
System Key:
12345 (must be nonzero numeric, max 5 digits)
5.
AP TX Power:
Level 4 (max)
6.
AP1
IP:
165.213.97.11
7.
AP1 RF CH:
1
8.
AP2
IP:
165.213.97.12
9.
AP2 RF CH:
11
10.
2
nd
WBS IP:
165.208.144.10 (leave it as default)
11.
Handset 1 IP:
165.213.97.101
12.
Handset 2 IP:
165.213.97.102
13.
Handset 3 IP:
165.213.97.103
14.
Handset 4 IP:
165.213.97.104
15.
WEP key:
Disable
16.
CODEC:
G729
Home Page
Table of Contents
