54 English
Tr
ouble
shoo
ting
Troubleshooting
Problem
Action
Fills with the wrong
water temperature.
•
Fully open both taps.
•
Make sure the temperature selection is correct.
•
Make sure the hoses are connected to the correct taps. Flush
water lines.
•
Make sure the water heater is set to supply a minimum
120 °F (49 °C) hot water at the tap. Also, check the water
heater capacity and recovery rate.
•
Disconnect the hoses and clean the mesh filter. The mesh filter
may be clogged.
•
While the washing machine fills, the water temperature may
change as the automatic temperature control feature checks
incoming water temperature. This is normal.
•
While the washing machine fills, you may notice just hot and/
or just cold water going through the dispenser when cold or
warm temperatures are selected.
This is a normal function of the automatic temperature
control feature as the washing machine determines the water
temperature.
Load is wet at the
end of a cycle.
•
Use the High or Extra High spin speed.
•
Use high efficiency (HE) detergent to reduce oversudsing.
•
Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
•
Make sure the drain hose is not kinked or clogged.
Leaks water.
•
Make sure the door is properly closed.
•
Make sure all hose connections are tight.
•
Make sure the end of the drain hose is correctly inserted and
secured to the drain system.
•
Avoid overloading.
•
Use high efficiency (HE) detergent to prevent oversudsing.
Has odours.
•
Excessive suds collect in recesses and can cause foul odours.
•
Run cleansing cycles to sanitize periodically.
•
Clean the door seal (diaphragm).
•
Dry the washing machine interior after a cycle has finished.
No bubbles are seen
(Bubbleshot models
only).
•
Overloading may screen bubbles.
•
Severely contaminated laundry may not generate bubbles.
WD90K6410OX_03745E-02_EN.indd 54
2016/11/10 17:01:28
