Troubleshooting
English
58
Troubleshooting
Problem
Action
Stops.
•
Make sure the washer's power cord is fully plugged in and
the circuit is live.
•
Check the fuse or reset the circuit breaker.
•
Close the door, and then press or tap
Start/Pause (Hold to
Start)
to start the washing machine. For your safety, the
washing machine will not spin unless the door is closed.
•
Before the washing machine starts to fill, it will make a
series of clicking noises to check the door lock, and then
does a quick drain.
•
There may be a pause or soak period in the cycle. Wait
briefly and the washing machine may start.
•
Make sure the inlet hose filters at the taps are not clogged.
Periodically clean the filters. See page
53
.
•
This problem can occur temporarily due to low voltage in
your household electrical system. It will be resolved when
the voltage returns to normal.
Fills with the wrong
temperature water.
•
Fully open both water taps.
•
Make sure the temperature selection is correct.
•
Make sure the hoses are connected to the correct water
taps. Flush the water lines.
•
Disconnect the hoses and clean the mesh filters. The water
inlet mesh filters may be clogged. See page
53
.
•
While the washing machine fills, the water temperature
may change as the automatic temperature control feature
checks incoming water temperature. This is normal.
•
While the washing machine fills, you may notice just hot
and/or just cold water going through the dispenser when
cold or warm temperatures are selected. This is a normal
function of the automatic temperature control feature as
the washing machine determines the water temperature.
Door (Lid) locked or will
not open.
•
While the washing machine is operating, press or tap
Start/Pause (Hold to Start)
to stop the washing machine.
•
It may take a few moments for the door lock mechanism to
disengage.
Untitled-6 58
Untitled-6 58
2021-05-25 8:26:42
2021-05-25 8:26:42
