34 English
Maint
enanc
e
Maintenance
Cleaning
Keep the washing machine clean to prevent deteriorated performance and to preserve its life
cycle.
Exterior
•
Use a soft cloth to wipe up all detergent, bleach, or other spills as they occur.
•
Clean the control panel with a soft, damp cloth. Do not use abrasive powders or cleaning
pads. Do not spray cleaners directly on the panels.
Tub Clean
Regularly run this cycle to clean the tub and to remove bacteria from it.
1.
Makes sure the tub is completely empty.
2.
Press
POWER
to turn on the washing machine.
3.
Press
TUB CLEAN
. You can also use Delay End with Tub Clean.
4.
Press and hold
START/PAUSE
.
CAUTION
Only run Tub Clean when the tub is completely empty. This may cause damage to the laundry
or a problem with the washing machine.
Tub Clean reminder
•
The indicator reminds you of cleaning the tub when necessary. If you happen to see
the indicator blinking after washing is complete, remove the laundry and run the Tub
Clean cycle.
•
You can ignore this reminder and continue to run cycles normally because this is
not a system failure. However, the reminder remains active for 6 consecutive cycles
immediately after each cycle is complete.
•
The reminder is activated once every 1-3 months, depending on the cycle count.
•
To keep the tub clean, it is recommended to run Tub Clean on a regular basis.
Built-in sink
1.
Open the door, and use a cloth or sponge to clean the Built-in sink.
2.
Press
Water Jet
to supply water to the board. Use this water to rinse the board.
WA8700K(HEATER)_DC68-03520W-02_EN.indd 34
2018-05-15 5:43:38
