89
Before Using the Recording and Timeshift Functions
Read these instructions before using
Recording
and
Timeshift
.
"
This function is only available on certain models in specific geographical areas.
Before using the recording and schedule recording functions
●
To set up a Schedule Recording, you must first set the TV's clock. Set the
Clock
(
Settings
System
Time
Clock
).
●
You can set up a maximum total of 30
Schedule Viewing
and
Schedule Recording
entries.
●
Recordings are DRM-protected and therefore cannot be played back on a computer or on a different
TV. In addition, these files cannot be played back on your TV if its video circuit has been replaced.
●
A USB hard drive with a speed of 5,400 rpm or above is recommended. However, RAID-type USB
hard drives are not supported.
●
USB memory sticks are not supported.
●
The total recording capacity may differ with the amount of available hard drive space and the
recording quality level.
●
Schedule Recording
requires at least 100MB of free space on the USB storage device. Recording will
stop if the available storage space falls below 50MB while recording is in progress.
●
If the available storage space falls below 500MB while both the Schedule Recording and Timeshift
functions are in progress, only the recording will stop.
●
The maximum recording time is 720 minutes.
●
Videos are played according to the TV settings.
●
If the input signal is changed while recording is in progress, the screen will go blank until the
change is made. In this case, recording will resume, but will not be available.
●
When using the Record or Schedule Recording function, the actual recording may start a second or
two later than the specified time.
Precautions and Notes
You can get instructions and information that you must read after installation.
