Digital Video Recorder SVR-1670
16
Digital Video Recorder SVR-1670
17
Setting the SVR-1670’s ID for the Remote Control
You can control up to 16 SVR-1670s from one remote control by creating unique IDs for each
SVR-1670.
· Setting the ID for the remote control device
1. From the OSD, select the Network menu.
2. Select the Remote submenu.
3. For the Remote Controller ID option, select an ID value. This will become the ID for the remote device
you plan to use.
· Setting the ID for the remote control device
Press the ID button on the remote controller and then the Channel button corresponding to the ID of the
DVR. If the selection is successful, the DVR plays a beep and you can remote control the SVR-1670. To
select an ID from 10 to 16, press +10 on the remote controller before the Channel button.
Chapter 2. SVR-1670 Description
Figure 2.6.2 Remote Control ID
Usable Range of Remote Control
Changing Batteries
Figure 2.6.3 Remote Control Device’s Usable Range
1.
To remove the rear battery cover, press it
forward.
2. Check the battery contacts inside the remote
controller: + and –. Insert each battery matching
the battery contacts and battery poles.
3. Reinsert the battery cover.
The Remote Control takes AAA-sized batteries. Here is how to insert new or replacement
batteries:
This chapter describes how to install the hardware. It includes instructions for installing the SVR-1670 in a rack
or on a desktop; connecting devices to the SVR-1670 including cameras, monitors, sensors, relays; in addition to
handling and preparing wiring.
The information is presented in these sections.
• 3. 1 Installing the SVR-1670 in a Rack
• 3. 2 Working with Input/Output Terminals
• 3. 3 Basic Connections to the SVR-1670
• 3. 4 Extended Connections to the SVR-1670
• 3. 5 Remote Monitoring and Control
• 3. 6 Hard Disk Drive Installation
Figure 2.6.3 shows an angle when the remote controller is pointed to the DVR remote controller
receiver.
Chapter 3. Hardware Installation