13
SPEED DOME CAMERA
12
SPEED DOME CAMERA
Bracket Setup for Installation
Initial Setting
●
Communication Protocol Setting (Installation Bracket)
Select and set SW1 on the installation bracket for setting the communication protocol.
●
Camera ID Setting (Mainframe front panel)
·
Set the Camera ID using the two rotary switches. SW1 and SW2
refer to the lower and upper positions, respectively.
SW1
0
1
2
3
4
5~F
Samsung
Samsung
Pelco-D
Pelco-D
Pelco-D
Reserve
9,600
19,200
2,400
4,800
9,600
Protocol
Baud Rate (BPS)
●
Baud Rate Setting by DVR Model
For control of the speed dome camera using DVR without a dedicated controller, set the baud rate by DVR
model as described below.
DVR Model
Protocol
SVR-430
SVR-900/1620
SVR-1630
9600,19200
9600,19200
9600,19200
9,600
4800, 9600
2400,4800,9600
Samsung
Pelco
·
EX) If the camera ID is number 1, set as described below.
SW2
SW1
0
1
Getting started
Note) Factory Default : 0 (Samsung, 9600)
Note) A faster rate may degrade stability.
The control function may not be available depending on the DVR Firmware version.
Be sure to install the latest DVR Firmware version.
SW2
SW1
Video Out
Alarm In 1
Alarm In 2
Alarm In 3
Alarm In 4
Alarm Out 1
Alarm Out 2
AC 24V Output (for Heater connection)
Mainframe 18PIN Connector
ENGLISH