English ·
1
You can’t make a connection using “WPS” between your router and the
camera.
What’s “WPS”?
WPS enables to make connection between the camera and the
Wireless Access Point with a simple click of the button.
Reason
1.
Your router doesn’t support “WPS” function.
2.
Your router can’t work well with the camera.
Solution
How to check if your router supports “WPS” or not.
• Refer to your router manual or contact to the manufacturer of your router.
In case your router doesn’t support it, refer to Quick Guide describing “
Connecting
via Wi-Fi without WPS feature
” or “
Wired Connection
”.
Operation Flow
1.
The camera power “
On
”
2.
Front LED is red.
3.
After about 1minute, front led is blinking white.
4.
Press the WPS button on the camera.
5.
Press the WPS button on the Wireless Access Point within 2min.
6.
The Wi-Fi status LED will become steady white once the camera is connected to
the Wireless Access Point. (may take up to 30sec).
If the Wi-Fi status LED (white) is not lit, repeat steps 2 through the end and check
it again.
7.
The Wi-Fi status LED will became steady white once the camera is connected to
server.
J
`
We tested WPS function with many routers. But there are some cases that the camera
can’t make connection with the router. So in that case we recommend you choose the
other methods describing on your Quick Guide. (ex. Connecting via W-iFi without WPS
feature or Wired Connection.)
P
roblem
C
ase
01
Network Troubleshooting Guide
SNH-1010N
WPS Button
WPS Button
<Modem>
<Wireless Access Point>
Internet Service
Wi-Fi
Indicator LED
