![background image](http://html.mh-extra.com/html/samsung/sm-j260m-ds/sm-j260m-ds_user-manual_1192061092.webp)
DRAFT
urement known as the Specific Absorption Rate (SAR). The SAR is a me
rate of absorption of RF energy by the human body expressed in units of
ogram (W/kg). The FCC requires wireless phones to comply with a safet
watts per kilogram (1.6 W/ kg). The FCC exposure limit incorporates a
antial margin of safety to give additional protection to the public and to ac
variations in measurements.
ests are conducted using standard operating positions accepted by the F
he phone transmitting at its highest certified power level in all tested frequ
Although the SAR is determined at the highest certified power level, the
SAR level of the phone while operating can be well below the maximum
because the phone is designed to operate at multiple power levels so a
not exceed the exposu
ne are performed in po
as required by the FCC.
Health and safety information
Exposure to Radio Frequency (RF) Signals
Certification Information (SAR)
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the exposure limits for radio frequency (RF) energy set
by the Federal Communications Commission (FCC) of the U.S. government. These
FCC exposure limits are derived from the recommendations of two expert
organizations, the National Counsel on Radiation Protection and Measurement
(NCRP) and the Institute of Electrical and Electronics Engineers (IEEE). In both
cases, the recommendations were developed by scientific and engineering experts
drawn from industry, government, and academia after extensive reviews of the
scientific literature related to the biological effects of RF energy.
The exposure limit set by the FCC for wireless mobile phones employs a unit of
meas
asure
of the
watts
per kil
y limit
of 1.6
subst
count
for any
SAR t
CC
with t
ency
bands.
actual
value.
This is
s to
use only the power required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a new model phone is available for sale to the public, it must be tested and
certified to the FCC that it does
re limit established by the
FCC. Tests for each model pho
sitions and locations (e.g. at
the ear and worn on the body)
For body worn operation, this model phone has been tested and meets the FCC RF
exposure guidelines when used with a Samsung accessory designated for this
product or when used with an accessory that contains no metal and that positions
the handset a minimum of 1.5 cm from the body.
Non-compliance with the above restrictions may result in violation of FCC RF
exposure guidelines.
SAR information on this and other model phones can be viewed on-line at
http://www.fcc.gov/oet/ea/fccid/
Please use the phone FCC ID number for search,
A3LSMJ260
M
.
Sometimes it may be necessary to remove the battery pack to find
the number. Once you have the FCC ID number for a particular phone, follow the
instructions on the website and it should provide values for typical or maximum
SAR for a particular phone. Additional product specific SAR information can also be
obtained at
http://www.fcc.gov/encyclopedia/specific-absorption-rate-sar-cellular-
telephones
Consumer Information on Wireless Phones