Samsung SID-47, User Manual, Page: 7 / 17

COLOR DOME CAMERA User’s Manual
12
COLOR DOME CAMERA User’s Manual
13
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 176° to each side direction and 352° on the whole.
• Tilt Base covers 75˚ angle.
• Rotate Base moves by 174° to each side direction and 348° on the whole.
2) Methods of adjustment
• The case of wall installation
… 1
After mounting the camera on a wall, adjusting the panning angle so that the camera can
face the direction to monitor when tilting.
… 2 And then adjust the tilting angle by rotating the tilt base.
… 3
Loosen the rotate base hold screw and adjust rotate base for the best monitoring.
… 4
Tighten tilt and pan base hold screw.
• The case of ceiling installation
… 1
After mounting the camera on a ceiling, adjusting the panning angle for better monitoring
area by rotating the pan base.
… 2
And then adjust the tilting angle by rotating the tilt base.
… 3
Loosen the rotate base hold screw and adjust rotate base for the best monitoring.
… 4
Tighten tilt and pan base hold screw.
Adjust the panning and tilting, rotating while watching the monitor
Installation
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate device.
Connect the adaptor to the power input connector as shown in the figure below. The
recommended adaptor specification for SID-47N/47P, SID-48N/48P, SID-49N/49P is AC 24V / 300mA
or DC 12V / 500mA.
Connection
Connecting to Monitor
Connecting to Power
75˚
176˚
174˚ 174˚
176˚
Pan Base
Tilt Base
Rotate Base
CCTV Camera
Intermediate End monitor
CCTV Camera
Monitor
---- Power Input Terminal
4) When an image on the screen is in focus, tighten the lens hold screw with proper strength so
as not to break out the screw.
5) Please change the EFL in LENS SAHDE menu after changing the lens, so that the function
operates properly.
* Please use a suitable screwdriver for the size of screw.