Samsung SID-47, User Manual, Page: 6 / 17

COLOR DOME CAMERA User’s Manual
10
COLOR DOME CAMERA User’s Manual
11
1) Separate the dome cover by counterclockwise rotation.
2) Separate the shield case by pulling from the camera body.
• The installation should be done by qualified
service personnel or system installers.
• If the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• To change the position of the cable, take
away the Hole Cover and pass the cable
through.
Notes
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Installation
Installation
When using the Ceiling bracket
1) Hold the ceiling bracket (located where the arrow
points to) and separate it from the main body of
the camera by rotating it counterclockwise.
(refer to the picture in 'Notes' on page 8)
2) Place the separated ceiling bracket so that the
“Front” side faces the area to be monitored and
install it with the M4 tapping screws.
3) To combine the main body with the ceiling bracket,
make sure that the pan base fixation screw face the
opposite side of the “Front” side of the ceiling
bracket and rotate it clockwise.
4) Adjust the camera lens to face the area to be
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
When changing the additional lens.
1) Loosen the lens hold screw at the side of lens holder.
2) Separate the built-in lens by counterclockwise rotation
and combine another lens. When combining the lens,
please clean the back side of lens and inside of the lens
holder.
3) Combining the lens by clockwise rotation, adjust the focus while watching the monitor.
• If you want to install the camera with the ceiling bracket combined, fix it using two M4 tapping
screws at the side of the main body (refer to the [Figure-2] on page 11).
Notes
Installation
Latch
[Figure-1]
Locking Direction
(Clockwise)
Dome Cover
Unlocking direction
(Counterclockwise)
Main Body
(Camera)
Original position of
the cable
Hole Cover
Unlocking
direction
M4 tapping
screw (provided)
An arrow for installing
directions
Dome Cover
Ceiling bracket
Locking direction
Lens hold
screw
[Figure-2]
M4 tapping
screw
Pan Base
fixation
screw