Samsung SHC-750, User Manual, Page: 14 / 22

Use the White Balance feature for screen color control.
1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to
“White Bal.”
2. Press the Left/Right buttons to select a mode.
Choose from the three modes shown below
ATW : One of the two modes below can be selected
• Normal - Use when the color temperature is between 1800~10500K
• Special - Use when the color temperature is between 1600~10500K
AWC : To find the optimum setting for the current illumination, point the camera at a
piece of white paper and then press the Set button. Repeat the process when
the illumination changes.
Manual: Manual control allows finer adjustments. Set the camera to ATW or AWC
mode first, and then change to Manual mode. Press the Set button. Decide on
the proper color temperature, and then adjust the values of Red and Blue while
observing the color changes of the subject on the screen.
This product generates a signal whenever motion is detected. Connecting an alarm device to
the product, therefore, may increase security efficiency. Motion detection signals are output
through the MD output port.
1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to
“Motion Det.”
2. Press the Left/Right buttons to select a mode (On/Off).
3. Press the Exit button to save the settings and exit.
COLOR CCD CAMERA User’s Manual 27 COLOR CCD CAMERA User’s Manual 26
SETUP
CAMERA ID OFF
BACKLIGHT OFF
WHITE BAL. ATW
MOTION DET. OFF
SETUP
CAMERA ID OFF
BACKLIGHT OFF
WHITE BAL. ATW
MOTION DET. OFF
LENS DC
Instruction: Camera Operation
White Bal Motion Det
• The White Balance may not function properly under the following conditions.
• If the subject’s environment has very high color temperatures (e.g. clear sky or
sunset).
• If the subject is in a dark environment
• If the camera is directly facing a fluorescent light, or if it is subject to extreme
fluctuations of light, the White Balance function may become unstable.
Caution
• Perform a lengthy test after setting MD, to confirm everything is operating properly.
• Use of the MD feature is not recommended if the camera is subject to direct
fluorescent light or extreme fluctuations of light; malfunction may occur.
• Sudden changes in subject illumination due to flashlights or fluorescent lighting
being turned on/off may cause malfunction.
• Other automatic algorithm execution speeds may slow down when the motion
detection feature is active.
• This feature is NOT suitable for fires, burglary, or
other similar security purposes. The manufacturer
will not be responsible for any accidents or loss that
may occur under these circumstances.
• The MD output port located on the back of the
product can be connected to external alarm devices.
Caution