![background image](http://html.mh-extra.com/html/samsung/sgh-t509/sgh-t509_service-manual_1190201005.webp)
SAMSUNG Proprietary-Contents may change without notice
2. Circuit Description
This Document can not be used without Samsung's authorization
2-1
2-1. SGH-T509 RF Circuit Description
2-1-1. RX PART
- FRONT END MODULE
(ANTENNA SWITCH RX SAW FILTER) (F102)
→
Switching Tx, Rx path for GSM850, DCS1800 and PCS1900 by logic controlling.
- FRONT END MODULE Control Logic
(F102)
→
Truth Table
VC1
VC2
Tx Mode (GSM850)
H
L
Tx Mode (DCS1800/1900)
L
H
Rx Mode (GSM850)
L
L
Rx Mode (DCS1800)
L
L
Rx Mode (PCS1900)
L
L
- VC-TCXO (TCX100)
This module generates the 26MHz reference clock to drive the logic and RF.
It is turned on when the supply voltage REFVCC is applied.
After buffering a reference clock of 26MHz is supplied to the other parts of the system
through the transceiver pin OUT.
- TRANSCEIVER (U102)
This chip is fully integrated GSM GPRS tri-band transceiver with VCO, loop filters and most of the
passive component in it.
And also fully integrated fractional N RF synthesizer with AFC control possibility, RF VCO with integrated supply
regulator. Semi integrated reference oscillator with integrated supply regulator.
RF Receiver front-end amplifies the GSM850, DCS1800 and PCS1900 aerial signal, convert the chosen channel
down to a low IF of 100kHz.
In IF section, further amplifies the wanted channel output level to the desired value and rejects DC.
2-1-2. TX PART
The transmitter is fully differential using a direct up conversion architecture. It consists of a signal side band
power up mixer. Gain is controlled by 6 dB via 3-wire serial bus programing. The fully integrated VCO and power
mixer achieve LO suppression, quadrature phase error, quadrature amplitude balance and low noise floor specification.
Output matching/balun components drive a standard 50 ohms single ended load.